手控車輛信號組-中英對照

手控：本操作必須通過鑰匙實現。轉向提供從一階段到另一階段的定時周期變更，作為當?shù)鼐幊�，但是沒有預置任何安全時間干擾 (例如琥珀色)、最小綠色和全部紅色。
a.閃爍模式：在閃爍模式條件下，琥珀車輛信號組的琥珀色閃爍，而全部其它信號熄滅。地方控制器的操作方式為：
i. 操作模式開關。
ii. 從中心的設備收到外部信號。
iii. 當探測到?jīng)_突綠色時，保護電路啟動。
14.控制面板： 控制面板提供下列功能：
接通： 手動/ 自動控制20
閃爍琥珀
開燈/關燈
隔離/通過控制器協調操作
從主裝置或者通過通訊損接受命令。
鑰匙操作
接通： 階段步驟

15.選擇：控制器包括下列功能：
3 kVA調光裝置
-輸出電壓： 200-160-120
行人要求設備
-顯示面板
-檢測器裝置

13. Manual Control: This shall be realized by key operated. switch to provide a fixed cyclic switching from phase to phase, as programmed locally but without interfering with any preset safety time such as amber, minimum green and all red.
a. Flashing Mode: In amber flashing mode the amber aspects of vehicle signal groups shall flash, while all other signals are extinguished. The local controller shall be forced into this operation mode by:
Operational mode switch.
External signal received from the central equipment.
The protection circuits, when conflicting greens are sensed.
14. Control Panel: The control panel shall provide the following functions: Switch: Manual/Automatic operation
 
Flashing Amber
Lamps on/Lamps off
Isolated/coordination operation shall be by the controller
receiving a command from the Master or by loss of communication. Key operated
switch: Phase step
15. Options:The controller shall accommodate the following functions: Dimming facility for 3 kVA load
Output voltages: 200-160-120 Pedestrian Demand facility
Indication Panel
Detector Unit
Housing: The equipment shall be housed in a weatherproof steel cabinet.
Provide circuit breaker(s) for terminating service wire. Circuit breaker(s) shall have minimum, 15 ampere rating.
Provide convenience receptacle in each cabinet. Receptacle to be a single German style 2 pin with ground (Legrand type 74130) outlet so located that by use of a socket attachment, a 60 watt lamp can be plugged in to provide light without disturbing any other equipment.
Provide an equipment grounding bus in each controller cabinet and ground the bus to the cabinet.

 2014.10.10